Toro Dingo TX 413 Service Manual page 108

10. Connect hydraulic hose (Fig. 250, Ref. C) to the
hydraulic lift valve fitting and tighten.
Figure 250
11. Connect the hydraulic hose, Ref. D, to the
hydraulic lift valve fitting and tighten (Fig. 251).
Figure 251
TX 413 Service Manual
12. Using a cable tie, tie the two hydraulic tilt hoses,
3" (7.62cm) from the barrel end fitting (Fig. 252).
DSC-0971
13. Start the unit and raise the loader arm assembly
to the full raised position. Install the cylinder lock
assembly on the hydraulic lift cylinder. Shut the
engine off (Fig. 253).
A
DSC-0970
A. Cylinder lock
Rev. 000
HYDRAULIC LIFT ASSEMBLY
Figure 252
Figure 253
DSC-0995
DSC-0965
7-19