Toro Dingo TX 413 Service Manual page 233

ATTACHMENTS
20. Loosely install bolts and nuts but DO NOT torque
yet.
Note: Do not torque until the chain is on the boom
and tension has been adjusted (Fig. 123).
21. Use a traction unit to lift the boom to aid in the install
of the chain.
22. Install chain on the sprocket end first and then over
the nose roller (Fig. 124).
10-34
Fig 123 CLR DSC-0368
Fig 124 CLR DSC-0370
23. Turn the adjuster bolt until 1-1/2" - 2-1/2" (3.8 -
6.35cm) droop between the bottom of the boom and
the top of the bottom chain span (Fig. 125).
24. When proper chain tension is obtained, tighten the
jam nut securely against the boom (Fig. 126).
Rev. 001
Fig 125 CLR DSC-0371
Fig 126 CLR DSC-0372
TX 413 Service Manual