Toro Dingo TX 413 Service Manual page 144

2. Lubricate and install the spool valve seals in the
top of the valve (Fig. 383).
Note: The thin wall of the seal goes into the valve
body first.
Figure 383
3. Lubricate the tilt spool. Install the spool in the left
port of the valve; twist and push gently, so you do
not damage the o-ring (Fig. 384).
Figure 384
TX 413 Service Manual
4. Lubricate and install the lift spool in the right port
of the valve, twist and push gently, so you do not
damage the o-ring (Fig. 385).
DSC-1416
5. Install the spring valve assembly with a hex
wrench and torque to 5 ft-lbs. (6.8 Nm). Lubricate
the spring with synthetic base grease grade
NLGI2 (Fig. 386).
DSC-1417
Rev. 000
HYDRAULIC LIFT ASSEMBLY
Figure 385
Figure 386
DSC-1418
DSC-1419
7-55