Joystick Assembly Installation
1. Install the joystick pivot with two hex head screws
(Fig. 360).
Figure 360
2. Install the nut holding the joystick joint to the
pivot for the lift and tilt operation (Fig. 361).
Figure 361
TX 413 Service Manual
3. Slide the end on the joystick joint onto the
joystick pin for the tilt cylinder (Fig. 362).
DSC-1728
4. Install the articulated holder with 3 hex head
screws and lock washers torque to 17.7 ft.-lbs.
(24 Nm) (Fig. 363).
DSC-1395
Rev. 000
HYDRAULIC LIFT ASSEMBLY
Figure 362
Figure 363
DSC-1726
DSC-1382
7-49