Wheel Motor Installation - Toro Dingo TX 413 Service Manual

DRIVE SYSTEM
11. Install a hydraulic floor jack under the wheel
motor. Remove the 4 wheel motor mounting bolts
(Fig. 481).
Figure 481
12. Before removing the wheel motor, install a
protective cap in the two open ports. Slide the
wheel motor inward from the frame until the
wheel motor shaft clears the frame and lower the
motor (Fig. 482).
Figure 482
Wheel Motors
For wheel motor service, refer to the Parker-Ross TF
wheel motor service manual (Toro P/N 492-4753).
8-18

Wheel Motor Installation

1. Position the wheel motor on a hydraulic floor
jack with the hydraulic line ports facing up. Slide
the wheel motor under the frame and raise
into the frame opening. Apply medium strength
threadlocking material to the mounting bolts and
torque the bolts to 75 + 8 ft-lbs. (102 + 11 Nm)
(Fig. 483).
DSC-0843
2. Remove the protective caps from the two open
ports.
Note: Before installing the hydraulic fittings,
replace the O-rings.
Install the two hydraulic fittings (Fig. 484).
DSC-0847
Rev. 000
Figure 483 DSC-0848
Figure 484 DSC-0846
TX 413 Service Manual