Traction Control Handle Assembly Installation - Toro Dingo TX 413 Service Manual

DRIVE SYSTEM
8. Tilt the top of the control assembly forward and
slide the assembly down and out of the control
handle and then out of the unit (Fig. 495).
Figure 495
9. Traction control assembly (Fig. 496).
A
Figure 496
A. RH Return Lever
B. Neutral Switch Stud
C. Neutral Return Spring
8-22
DSC-1255
B
C
D
E
F
DSC-1256
D. LH Return Lever
E. Neutral Centering Cam
F. Reverse Lever Asm.
Traction Control Handle Assembly
Installation
1. Install traction control assembly, tilting the top
of the control assembly forward so the control
handle can be installed onto the drive rod
assembly; do not install the bolt and nut.
2. Install flat washer, spring washer, washer, and
then the bushing on each end of the control
support assembly (Fig. 497).
3. Lift up slightly on the neutral centering lever and
align the bushings to the bolt holes and install the
four bolts and nuts and tighten (Fig. 498).
Rev. 000
Figure 497 DSC-1262
Figure 498 DSC-1252
TX 413 Service Manual