Reassemble the Nose Roller
1. Reassemble in reverse order. Place a roller spacer
against each side of the bearing surface (Fig. 088).
Install the roller caps next, aligning the square of the
cap with the square of the bearing hub (Fig. 089).
TX 413 Service Manual
Fig 088
CLR DSC-0246
Fig 089
CLR DSC-0247
ATTACHMENTS
2. Slide the nose roller back into the boom. Install the
screw, washer and pin assembly. Make sure the pin
assembly lines up with roller caps and bearing hub
(Fig. 090).
3. Torque the screw to 150 ft-lbs. + 15 ft-lbs. (203 + 20
Nm).
4. Grease the pin assembly with high temperature
Mobil grease (Fig. 091).
Rev. 001
Fig 090
CLR DSC-0248
Fig 091
CLR DSC-0250
10-25