Loader Valve Disassembly and Assembly
1. Before disassembly of any hydraulic component,
use a clean, dirt-free work surface and clean
solvent to prevent system contamination (Fig.
352).
A
B
C
Figure 352
A. Power beyond valve
B. Work port relief
C. Spring Cap
Joystick Assembly Removal
1. Remove handle (Fig. 353).
Figure 353
TX 413 Service Manual
D
E
B
F
DSC-1377
D. Rubber Bellows
E. System relief
F. Detent spring cap
DSC-1436
HYDRAULIC LIFT ASSEMBLY
1. Remove tie cable around the rubber bellows and
remove the joystick assembly (Fig. 354). Wipe
excess grease from the joystick.
2. Remove the 3 hex head screws and spring lock
washers, and remove the articulated holder (Fig.
355).
Rev. 000
Figure 354
DSC-1381
Figure 355
DSC-1382
7-47