Toro Dingo TX 413 Service Manual page 64

6. Remove the upper end of the inlet hydraulic line
at the T-fitting adapter, (page 6-2, Ref. 6), located
on the lower hydrostatic pump (Fig. 107, top
view).
Figure 107
7. On the lower side of the T-fitting adapter, remove
the hydraulic inlet line, (page 6-2, Ref. 7), from
the lower hydrostatic pump that runs to the upper
hydrostatic pump (Fig. 108, top view).
Figure 108
TX 413 Service Manual
8. Loosen and remove the hydraulic inlet line, (page
6-2, ref 7), located on the back side of the upper
hydrostatic pump (Fig. 109).
DSC-0861
9. Disconnect the hydrostatic case drain line from
the T-fitting adapter, (page 6-2, Ref. 5), at the
lower hydrostatic pump (Fig. 110, rear view).
DSC-0863
Rev. 000
HYDRAULIC SYSTEM
Figure 109 DSC-0864
Figure 110 DSC-0869
6-7