Toro Dingo TX 413 Service Manual page 163

DRIVE SYSTEM
2. Push the track under and between the road
wheels. Starting at the bottom of the tension
wheel, install the track around the wheel by
rotating the track rearward while pushing the lugs
into the wheel (Fig. 450).
Figure 450
3. Turn the tensioning screw counter-clockwise,
(Fig. 451), until the distance between the tension
nut and the back of the tensioner arm is 2-1/2
inches (6.35cm) (Fig. 452).
Figure 451
8-10
1. = 2-1/2 inches
(6.35cm)
A. Tension nut
DSC-0796
4. Align the closest notch in the tension screw to the
locking bolt hole and secure the screw with the
locking bolt and nut (Fig. 453).
DSC-0794
Rev. 000
A
Figure 452
B. Tensioner Arm
Figure 453
TX 413 Service Manual
B
track install #3
DSC-0793