Shaft Removal - Toro Dingo TX 413 Service Manual

ATTACHMENTS
Note: Make sure you retain the motor shaft key (Fig.
024).

Shaft Removal

1. Using a flat screwdriver, pry the 2 bearing lock
washer tangs out of the notches on the bearing nut.
2. Using the TOR 6002 spanner socket, align the tabs
of the socket with the notches on the bearing nut
(Fig. 025 and Fig. 026).
A. Lockwasher tang
10-8
Fig 024 CLR DSC-0110
A
Fig 025 CLR DSC-0113
B. Bearing nut notch
3. Using 7/8" round stock to prevent the auger shaft
from turning, remove the bearing nut using a breaker
bar to loosen the nut (Fig. 027).
B
Rev. 001
Fig 026 CLR DSC-0115
Fig 027 CLR DSC-0121
TX 413 Service Manual