Toro Dingo TX 413 Service Manual page 121

HYDRAULIC LIFT ASSEMBLY
14. Remove the two vent hoses, located above
the oil filter bracket. The top vent is for the fuel
tank (A) and the bottom vent is for the hydraulic
reservoir tank (B) (Fig. 300).
Figure 300
15. Remove the bolt and nut at pivot pin for the
loader arm assembly (Fig. 301).
Figure 301
7-32
16. With a hammer and a long pipe, tap the pivot pin
out of the loader arm assembly (Fig. 302).
A A
B B
DSC-1064
17. Lift the loader arm assembly from the unit (Fig.
303).
A. Tilt cylinder hoses
DSC-1057
Rev. 000
Figure 302
A A
Figure 303
B. Auxiliary hoses
TX 413 Service Manual
DSC-1058
B
DSC-1060