Toro Dingo TX 413 Service Manual page 208

Nut removed (four notches) (Fig. 028).
4. Using two pairs of needle nose pliers, remove the
bearing lockwasher (Fig. 029).
Note: Do not reuse. Discard and replace with new
lockwasher.
TX 413 Service Manual
Fig 028 CLR DSC-0122
Fig 029 CLR DSC-0125
ATTACHMENTS
5. Raise the loader arms so the auger shaft clears the
surface area it is resting on.
6. Rotate the auger housing up until you can slide a
1/2" x 2-3/4" bolt into the hole on the cradle arm to
lock the auger housing in place (Fig. 030).
7. Slide auger shaft from auger housing (Fig. 031).
Rev. 001
Fig 030 CLR DSC-0144
Fig 031 CLR DSC-0128
10-9