Toro Dingo TX 413 Service Manual page 205

ATTACHMENTS
Install dust caps over the ends (Fig. 016).
2. Mark the hydraulic hose fitting and motor fitting to
identify their location when reinstalling (Fig. 017).
Note: The hose with the male nipple is on the right
hand side of the power head from operator
position and the hose with the female coupler
is to the left side of the power head from the
operator position.
10-6
Fig 016 CLR DSC-0103
Fig 017 CLR DSC-0377
3. Place a drain pan under hydraulic fittings to catch
hydraulic oil in the lines. Then using a 15/16" wrench
on the hydraulic line fitting and a 3/4" open end
wrench to hold the motor fitting, disconnect hydraulic
lines from the hydraulic motor (Fig. 018).
4. Cap the two 90
of the hydraulic lines, to prevent contamination (Fig.
019).
Rev. 001
Fig 018
o
motor fittings, as well as the ends
Fig 019
TX 413 Service Manual
CLR DSC-0097
CLR DSC-0104