Toro Dingo TX 413 Service Manual page 115

HYDRAULIC LIFT ASSEMBLY
3. Make sure the two hydraulic lift hoses are routed
under the other four hydraulic hoses; 2 hydraulic
hoses for the auxiliary couplers and two for the
hydraulic tilt cylinder (Fig. 277).
Figure 277
4. Apply a small amount of grease to the pivot pin
on the ram end of lift cylinder and slide the pin
through, then align the bolt hole. Use a socket
or pipe to tap the pivot pin in, so damage to the
grease fitting does not occur (Fig. 278).
Install bolt and nut, then tighten. With a grease
gun, apply grease to the grease fitting.
A
B
Figure 278
A. Pin
7-26
DSC-1028
DSC-1022
B. Socket or pipe
Rev. 000
5. Apply a small amount of grease to the pivot pin
on the barrel end of the lift cylinder and slide
the pin through, then align the bolt hole. Use a
socket or pipe to tap the pivot pin in, so damage
to the grease fitting does not occur (Fig. 279).
Install bolt and nut, then tighten. With a grease
gun, apply grease to the grease fitting.
Figure 279
6. Connect the hydraulic hose to the hydraulic fitting
on the lift valve and tighten (Fig. 280).
Figure 280
DSC-1023
DSC-1024
TX 413 Service Manual