Toro Dingo TX 413 Service Manual page 113

HYDRAULIC LIFT ASSEMBLY
8. Mark the hydraulic hose and fitting at the ram
end of the hydraulic lift cylinder (Fig. 269).
Figure 269
9. Remove the hose clamp located in the back at
the lower left corner and cut the tie cable strap
holding the hydraulic hoses together (Fig. 270).
Figure 270
7-24
10. Remove the pivot pin on the barrel end of the
hydraulic cylinder by using a drift punch and
hammer, tapping the pin out from the inside of
the frame, toward the outside (this is a top view
of the barrel end of the pivot pin) (Fig. 271).
Note: It may be necessary to remove the
hydraulic return line to the reservoir to get
more clearance to remove the pivot pin.
DSC-1005
A. Pin
11. Support the hydraulic cylinder prior to removing
the pivot pin at the ram end of the hydraulic lift
cylinder. Using a drift punch and hammer, tap
the pin out from the inside of the loader arm
assembly, toward the outside (Fig. 272).
DSC-0969
Rev. 000
A A
Figure 271
B. Punch
Figure 272
TX 413 Service Manual
B B
DSC-1014
DSC-1015