Toro Dingo TX 413 Service Manual page 84

8. Install the seal and the back-up ring following
steps 3 and 4.
9. Lubricate and install the thrust plate with the
seals facing the rear cover and the alignment
mark facing you (Fig. 181).
Figure 181
10. Lubricate and install new seals on the both ends
of the body (Fig. 182).
Figure 182
TX 413 Service Manual
11. Install the body on the front cover, making sure
the marks are aligned (Fig. 183).
DSC-1489
12. Install the rear cover on the body; again, make
sure the marks are aligned (Fig. 184).
DSC-1490
Rev. 000
HYDRAULIC SYSTEM
Figure 183 DSC-1491
Figure 184 DSC-1492
6-27