Spool Assembly - Toro Dingo TX 413 Service Manual

HYDRAULIC LIFT ASSEMBLY
12. Using a tool with a 90° angle, (for example, a
snap ring pliers with 90° tips) remove both the
spool valve seals located at the top of the valve
(Fig. 379).
Figure 379
13. Remove the two o-rings located at the bottom
of the valve; a small dental pick works to help
remove the o-rings (Fig. 380).
Figure 380
7-54

Spool Assembly

Replace all seals and o-rings with new parts.
Lubricate the valve, o-rings, and spool with 10W-30
oil prior to installation (Fig. 381).
A B
I
H C
DSC-1411
A. Spring Cap
B. Tilt Spring
C. O-Ring
D. Valve Body
E. Tilt Spool
1. Lubricate the two o-rings located at the bottom of
the valve and install (Fig. 382).
DSC-1413
Rev. 000
C D
Figure 381
F. Spool Valve Seal
G. Lift Spool
H. Detent Spring
I. Detent Cap
Figure 382
TX 413 Service Manual
F
E
G
F
DSC-1414
DSC-1415