Toro Dingo TX 413 Service Manual page 209

ATTACHMENTS
8. Using a 1/8" hex wrench, remove the three hex head
screws from the bearing protector plate (Fig. 032).
Remove the plate to access the 2 bearings and
spacer.
9. Remove the 1/2" x 2-3/4" bolt securing the auger
housing to the cradle. Swing the auger housing so
the shaft end is facing up (Fig. 033).
10-10
Fig 032
CLR DSC-0130
Fig 033 CLR DSC-0138
10. Using a hammer and punch, go around the circum-
ference of the bearing to drive the first bearing out.
With the bearing removed, the spacer will slide out
(Fig. 034 and Fig. 035).
A
A. Spacer
Rev. 001
Fig 034 CLR DSC-0132
B
Fig 035
DSC-134
B. Bearing
TX 413 Service Manual