Brake Assembly Removal - Toro Dingo TX 413 Service Manual

DRIVE SYSTEM

Brake Assembly Removal

1. Remove the rear cover. Disconnect the battery
negative cable and then the positive cable.
Remove the battery. Remove the battery bracket.
2. Disconnect brake cable by removing the bolt and
nut that holds the brake cable end to the brake
shaft assembly (Fig. 502).
Figure 502
3. Slide the boot up on the cable and remove the
adjusting nut on the cable and remove the brake
cable from the bracket on the frame (Fig. 503).
Figure 503
8-24
4. Remove the two bolts and nuts that hold the
cable brackets to the brake bars (Fig. 504).
5. Carefully slide the brake spring and cable
brackets off the brake bar, sliding it off the right
side first and then remove it off the left side (Fig.
DSC-1265
505).
DSC-1266
Rev. 000
Figure 504 DSC-1268
Figure 505 DSC-1269
TX 413 Service Manual