Display Device; Display Fan - H3C S3100-52P Command Manual

Command Manual – System Maintenance and Debugging
H3C S3100-52P Ethernet Switch

3.1.5 display device

Syntax
display device [ manuinfo [ unit unit-id ] | unit unit-id ]
View
Any view
Parameter
manuinfo: Displays the manufacture information of the specified switch.
unit-id: Unit ID of a switch.
Description
Use the display device command to display the information, such as the module type
and operating status, about each board (main board and sub board) of a specified
switch.
You can use this command to display the following information about each board: slot
number, sub slot number, number of ports, versions of PCB, FPGA, CPLD and
BootROM software, address learning mode, interface board type, and so on.
Example
# Display board information of this switch.
<H3C> display device
Unit 1
SlotNo SubSNo PortNum PCBVer FPGAVer CPLDVer BootRomVer AddrLM Type
0 0
0 1

3.1.6 display fan

Syntax
display fan [ unit unit-id [ fan-id ] ]
View
Any view
Parameter
unit-id: Unit ID of a switch.
fan-id: ID number of a fan.
48 REV.C NULL
4 REV.C NULL
3-4
Chapter 3 Device Management Commands
001 101 IVL
001 NULL IVL
State
MAIN Normal
4 GE Normal