Roof Molding Removal - Mazda RX-8 Manual

Hide thumbs Also See for RX-8:

Table of Contents

3. Install in the reverse order of removal.

EXTERIOR MOLDING

FRONT BELTLINE MOLDING REMOVAL/INSTALLATION

1. Remove the inner garnish. (See INNER GARNISH REMOVAL/INSTALLATION .)

2. Remove the power outer mirror installation screws and move the mirror to access the front end of the

front beltline molding. (See POWER OUTER MIRROR REMOVAL/INSTALLATION .)

3. While partially peeling back the front beltline molding, detach tabs A along the direction (1) shown in

4. Remove clip B and front beltline molding.

5. Install in the reverse order of removal.

ROOF MOLDING REMOVAL

1. Detach the roof molding from the T-stud at section A, using a flathead screwdriver or equivalent tool.

2. While pulling the roof molding up, detach it from the clips at sections B, and then remove the roof