1F2-66 M161 ENGINE CONTROLS
CRANKSHAFT POSITION SENSOR
1 Crankshaft Position Sensor (connector)
2 Bolt (M6 X 14) ........................................ 9-11 Nm
Removal & Installation Procedure
1. Disconnect the wiring connector at the crankshaft position
sensor.
2. Unscrew the bolt (2) and remove the crankshaft position
sensor unit (3).
Installation Notice
Tightening Torque
3. Installation should follow the removal procedure in the
reverse order.
3 Sensor Unit
9 - 11 Nm