SSANGYONG 1999 Musso Service Manual page 1202

5D1-32 TRANSFER CASE (PART TIME 4408)
Cover
1. Position the cover to be the open end up on the work table.
2. Position the end of needle bearing to be identification mark
up and press into the cover until upper end of bearing is
40.47 - 40.97mm below cover face that contacts with transfer
case.
3. Press the ball bearing into the cover and install the snap
ring .
4. Install remaining parts as follows.
Install the 4 O-rings on the stud bolts of the clutch coil
assembly.
Install the clutch coil assembly inside the cover and
tighten 3 nuts.
Tightening Torque
Install the bearing and motor bearing into the cover.
8 - 11 Nm
18 Oil Seal
19 Bushing
20 Nut
21 Clutch Coil Assembly
22 Snap Ring
23 Ball Bearing
24 Needle Bearing
25 Cover