SSANGYONG 1999 Musso Service Manual page 234

Tools Required
001 589 72 21 00 Torque Wrench
116 589 20 33 00 Sliding Hammer
116 589 01 34 00 Threaded Bolt
Removal & Installation Procedure
1. Remove the power steering belt pulley and A/C compressor
bracket.
2. Remove the oil line from power steering pump.
3. Rotate the crankshaft so that the piston of number, cylinder
is at ATDC20°
4. Put the alignment marks (arrows) on the timing chain and
camshaft sprocket.
5. Remove the chain tensioner.
Installation Notice
Tightening Torque
6. Remove the intake and exhaust camshaft sprocket
(remove the camshaft adjuster assembly in E23 engine).
Installation Notice
Tightening Torque
Notice
The flange bolt is designed to be used only once, so always
replace with new one.
7. Remove the guide rail pin using the sliding hammer (02)
and the threaded pin (03).
Notice
Apply the sealant on guide rail pin when installation.
78 - 88 Nm
1st step 18 - 22 Nm
2nd step 85° - 95°
Sliding Hammer 116 589 20 33 00
Threaded Pin 116 589 02 34 00
M161 ENGINE MECHANICAL 1B2-45