SSANGYONG 1999 Musso Service Manual page 1131

5B-24 MANUAL TRANSMISSION
7. Install the counter shaft rear bearing outer race, shim and
retainer.
Tightening Torque
Using a punch and hammer, bend the lock tabs on the
retainer.
8. Install the following parts :
Install the main shaft into case.
Install the main shaft rear bearing outer race into the
rear of the case.
Install the 4th speed blocking ring onto the front of the
main shaft.
Install the input shaft onto the front of the main shaft.
Install the input bearing retainer without shim onto the
front of the case.
Using a torque wrench, tighten the 4 bolts.
9. Install the 5th speed drive gear and blocking ring on the
counter shaft.
10. Install the 5th synchronizer and rail/fork.
11. Install the 5th synchronizer snap ring and oiling funnel.
12. Align the slots of the lever with the rollers of the reverse
fork and 5th shift rail. Apply sealer on the 5-R lever pivot
bolt and install it into the case.
Tightening Torque
13. Using a needle nose pliers, install the 5-R lever clip.
39 - 52 Nm
28 Nm