Main Shaft - SSANGYONG 1999 Musso Service Manual

MAIN SHAFT

Disassembly Procedure
1. For correct reassemble, place an alignment mark on the 3-
4 Synchronizer hub and sleeve.
2. Using a hydraulic press and puller plate, remove the 3-4
Synchronizer assembly and the 3rd speed gear.
3. Remove the 3rd speed gear bearing and spacer.
4. Using a snap ring pliers, remove the 2nd speed gear snap
ring.
5. Remove the 2nd speed gear thrust washer.
6. Remove the 2nd speed gear, bearing and spacer.
MANUAL TRANSMISSION 5B-27