Test Procedure - SSANGYONG 1999 Musso Service Manual

1F3-38 OM600 ENGINE CONTROLS
Tools Required
617 589 08 21 00 Position Sensor

Test Procedure

1. Remove the screw plug (5) and seal (4) and collect oil in a
suitable vessel.
2. Install the position sensor (1) into the governor housing of
the injection pump to be the guide pin of the position sensor
facing up.
3. Connect the battery terminal of position sensor (1) to positive
terminal (+) of battery.
4. Rotate the crankshaft by hand (in direction of engine rotation)
until the lamp 'B' lights up. Rotate the crankshaft carefully
further until both lamps 'A and B' come on. In this position,
check the Rl value on the crankshaft vibration damper.
Specification
Notice
If only lamp 'A' lights up, repeat the test and if out of
specification, adjust start of delivery.
Position Sensor 617 589 08 21 00
ATDC 14° - 16°