SSANGYONG 1999 Musso Service Manual page 513

1D2-8 M161 ENGINE COOLING
Tools Required
111 589 02 01 00 Open End Wrench
111 589 00 40 00 Open End Wrench
Removal & Installation Procedure
1. Install the holder (special tool : 111 589 00 40 00) to the bolt
at the pulley as shown in the right figure to hold the pulley.
2. Remove the viscous clutch using an open end wrench
(special tool : 111 589 02 01 00).
Installation Notice
Tightening Torque
Notice
The union nut is left threaded screw.
3. Remove the 3 bolts (1) from the viscous clutch and remove
the cooling fan and the viscous clutch.
Installation Notice
Tightening Torque
Notice
You may change the procedure (2) and (3) if necessary.
4. Installation should follow the removal procedure in the
reverse order.
40.5 - 49.5 Nm
9 - 11 Nm