SSANGYONG 1999 Musso Service Manual page 895

4. Slightly tapping the yoke shoulder using a brass hammer,
remove the bearing. Remove the remaining bearings in the
same way.
5. If difficult to remove, clamp the yoke side in a vise and tap
off the needle bearing, using a proper tool.
6. Disassemble the universal joint parts.
As axles move up and down, universal joints allow drive
angles to change without binding propeller shaft.
PROPELLER SHAFT 3C-5
1 Grease Nipple 4 Seal
2 Flange Yoke 5 Needle Roller Bearing
3 Spider 6 Snap Ring