SSANGYONG 1999 Musso Service Manual page 231

1B2-42 M161 ENGINE MECHANICAL
10. Remove the cylinder head bolts in the reverse order of
the numerics (No.10 ® No.1).
Installation Notice
Tighten the bolts as numerical order with specified torque
(No.1 ® No.10).
Tightening Torque
Notice
Operate during engine cooling.
11. Remove the No. 1 bearing cap of the exhaust camshaft.
Installation Notice
Tightening Torque
12. Install the special tool (05) on the bearing cap removed
place and hook the engine hoist into them and remove
the cylinder head carefully.
13. Check the cylinder head mating surface and clean the
crankcase head bolt mounting hole.
14. Replace the cylind head gasket with new one.
1st step 55 ± 5 Nm
2nd step + 90°
3rd step + 90°
22.5 - 27.5 Nm
Holder 104 589 00 40 00
1 Cylinder Head Bolt
2 M8 X 35 Bolt & Washer
3 Bearing Cap
4 Engine Hoist
5 Gasket
6 Hanger Bracket