Coolant Temperature Sensor - SSANGYONG 1999 Musso Service Manual

1F2-76 M161 ENGINE CONTROLS

COOLANT TEMPERATURE SENSOR

1 Artificial Resin Housing
2 Metal Housing
3 NTC (negative temperature coefficient) Resistor
Removal & Installation Procedure
1. Remove the pressure by opening the pressure cap in the
coolant subtank.
2. Disconnect the connector and remove the coolant
temperature sensor.
Installation Notice
Tightening Torque
Replace the seals with new one.
3. Installation should follow the removal procedure in the
reverse order.
4. Check for leaks at each connections after starting the engine.
4 Connector
5 Coolant Temperature Sensor
18 - 22 Nm