Camshaft Position Sensor - SSANGYONG 1999 Musso Service Manual

1F2-68 M161 ENGINE CONTROLS

CAMSHAFT POSITION SENSOR

1 Bolt (M6 X 14) ......................................... 9-11Nm
2 Camshaft Position Sensor
Removal & Installation Procedure
1. Disconnect the wiring connector from the camshaft position
sensor.
2. Unscrew the bolt (2) and remove the camshaft position
sensor.
Installation Notice
Tightening Torque
3. Check the clearance and replace the shim if necessary.
4. Check the O-ring for damage and replace it if necessary.
5. Installation should follow the removal procedure in the
reverse order.
3 Shim
5 O-ring
9 - 11 Nm