SSANGYONG 1999 Musso Service Manual page 1093

5A-116 AUTOMATIC TRANSMISSION
18. Install the gasket on the pump cover.
19. Install the cover plate, solenoid 7 with the retainer and the
solenoid wiring retainer to the pump cover, ensuring that
the periphery of the cover plate is flush with the periphery
of the pump cover. Refer to figure 8.34.
Tighten the screws to specification in the order (1-5), shown
in figure 8.44.
20. Tighten the solenoid 7 screw. Refer to figure 8.39.
Notice
Check that neither the wiring nor the connector protrudes
excessively, in order that at assembly neither the wiring
and the connector contacts or rubs on the input shaft or
the C1/C2 clutch cylinder.
21. Assemble the pump to the pump cover.
Tighten all bolts and the crescent screw finger tight,
ensuring that the pump is flush against the pump cover.
Tighten the bolts and the screw to specification in the order
(A - F), shown in figure 8.44.
22. Install the pump to transmission case gasket onto the case.
23. Fit the 'O' ring to the pump cover outer diameter.
24. Install the pump and cover assembly over the input shaft
being careful not to damage the sealing rings. Tighten the
pump cover to case bolts to specification. Refer to figure
8.45.
Figure 8.44 - Pump Bolt Tightening Sequence
Figure 8.45 - Tightening Sequence Pump to
Case