SSANGYONG 1999 Musso Service Manual page 1088

7. Coat the small nylon thrust spacer with petroleum jelly and
install it over the overdrive shaft. Refer to figure 8.19.
8. Carefully fit the overdrive shaft into the C1 cylinder so as
not to damage the sealing ring.
9. Fit the small bronze C1 hub thrust washer in place with
petroleum jelly. Refer to figure 8.19.
10. Check the input shaft for any defect. Fit the input shaft
into the cylinder and secure it with the circlip, ensuring
that the circlip is completely seated in the groove.
11. Coat the sealing rings with petroleum jelly and fit onto the
input shaft.
12. Assemble the C1/C2/C4 clutch assembly to the C3 clutch
and sun gear assembly. Refer to figures 8.32 and 8.33.
13. Install this assembly in the transmission case.
AUTOMATIC TRANSMISSION 5A-111