SSANGYONG 1999 Musso Service Manual page 1190

5D1-20 TRANSFER CASE (PART TIME 4408)
<Adapter, Input Shaft and Carrier Gear>
1. Remove the breather.
2. After removing 6 bolts, remove the front adopter by
separating the adapter sealer bond from the case
using a screw driver.
Notice
Be careful not to damage the contacting surface of
the case and adapter.
3. Remove the adapter assembly, input shaft assembly
and carrier gear assembly.
4. Remove the snap ring and oil seal from the front
adapter.
72 Breather
73 Bolt
74 Adapter Assembly
75 Snap Ring
76 Oil Seal
77 Spiral Pin
78 Front Adapter
79 Retaining Ring
80 Bearing
81 Input Shaft Assembly
5. After removing snap ring, pull out the bearing and
thrust washer from the input shaft assembly and
separate the input shaft assembly from the carrier
gear assembly.
6. Remove the needle bearing and sleeve bearing from
the input shaft assembly.
7. Remove the retaining ring, thrust plate rind sun gear
from the planet carrier assembly.
Notice
Do not disassemble the planet carrier assembly.
82 Sleeve Bearing
83 Needle Bearing
84 Input Shaft
85 Thrust Bearing
86 Carrier Gear Assembly
87 Retaining Ring
88 Thrust Plate
89 Sun Gear
90 Planet Carrier Assembly
111 Case