Power Train System - SSANGYONG 1999 Musso Service Manual

5A-42 AUTOMATIC TRANSMISSION
The Power Train System consists of:
A torque converter with single face lock-up clutch
Four multi-plate clutch assemblies
Two brake bands
Two one-way clutches
Planetary gearset
Parking mechanism
A conventional six pinion Ravigneaux compound planetary gearset is used with overdrive (fourth gear) being obtained
by driving the carrier.
The cross-sectional arrangement is very modular in nature. Four main sub-assemblies are installed within the case
to complete the build. These sub-assemblies are:
Gearset-sprag-centre support
C1 -C2-C3-C4 clutch sub-assembly
Pump assembly
Valve body assembly
One, or a combination of selective washers are used between the input shaft flange and the number
control the transmission end float. This arrangement allows for extensive subassembly testing and simplistic final
assembly during production.
A general description of the operation of the Power Train System is detailed below. Refer to table 4.1 and figure 4.1.
First gear is engaged by applying the C2 clutch and locking the 1-2 One Way Clutch (1-2 OWC). The 1-2 shift is
accomplished by applying the B1 band and overrunning the 1-2 OWC. The 2-3 shift is accomplished by applying the
C1 clutch and releasing the B1 band. The 3-4 shift is accomplished by re-applying the B1 band and overrunning the
3-4 OWC. Reverse gear is engaged by applying the C3 clutch and the B2 band.
The C4 clutch is applied in the Manual 1,2 and 3 ranges to provide engine braking. In addition, the C4 clutch is also
applied in the Drive range for second and third gears to eliminate objectionable freewheel coasting. The B2 band is
also applied in the Manual 1 range to accomplish the low-overrun shift.
Both the front and rear servos are dual area designs to allow accurate friction element matching without the need for
secondary regulator valves. All the friction elements have been designed to provide low shift energies and high static
capacities when used with the new low static co-efficient transmission fluids. Non-asbestos friction materials are used
throughout.
Table 4.1 - Engaged Elements vs Gear Ratios
Gear
Gear
Ratio
First
2.741
Second
1.508
Third
1.000
Fourth
0.708
Reverse
2.428
Manual 1
2.741
* For Certain Vehicle Applications, Refer to the Owner's Manual.

POWER TRAIN SYSTEM

C1 C2 C3
X
X
X
X
X X
X
X
ELEMENTS ENGAGED
B1
C4 B2
X
X
X
X
X
X
X
4 bearing to
1-2 3-4 LU
OWC OWC CLUTCH
X X
X
X X*
X