DO NOT DISTURB Press the DND key to set and to cancel.
Lift handset, press PAGE and begin speaking after the tone.
To build a conference call, with the first caller on the line, press
CONF, then dial the next party. When they have answered,
press the CONF key to join everyone. Repeat to add more
callers. You can only have a total of 3 people in the conference.
If you dial an extension internally and you receive a
busy tone, press VO to over-ride the existing conversation. The
outside caller will not hear you and you will not hear
Either person until the inside user you have voice over'd chooses
to reply. To reply to a user who has used this feature to reach
you, press the REPLY key on your phone. The key will light up
when you conversing with the internal caller and will not light
when you are conversing with your external caller. The external
caller never hears either side of the conversation.
The DIRECTORY key is a Caller ID scroll key. Press the
DIRECTORY key to display up to 30 incoming calls. A is for
calls that you’ve answered and M are ones that you missed.
To use the Speed Dial, press the SYS or the STA key
in the display of your phone, then press the UP or DOWN key to
scroll to the number you wish. Once the number is displayed,
pick up the phone. To search for a number by name, press the
SYS or the STA key in the display of your phone, then using the
key pad on your phone, press the number with the corresponding
first letter of the name you are looking for and then press the UP
or DOWN key to start the search. Once the number is displayed,
pick up the phone to complete the call. If you know the 2 digit
buffer number where you number is stored, you can press
REDIAL and then the 2-digit number to dial.
SPEED DIAL (Station)
1. Press the FEATURE key
2. Press the REDIAL key.
3. Dial the Speed Dial Memory location 80~99.
4. Dial the trunk access code, i.e. 9 (if necessary).
5. Dial the telephone number to be stored (24 digits
6. Press the HOLD key (if entering a name) and dial
the name of the party (13 letters maximum). Use the
# key to move to the next character if it is on the same
key or press the # key twice to create a space.
7. Press the FEATURE key again