Trunk Name/Number Assignment - NEC Electra Elite IPK Programming Manual

Electra Elite IPK
___________________________________________________________________________________
3-00

Trunk Name/Number Assignment

General Description
Use this Memory Block to specify telephone name/number for the CO/PBX line that is
displayed when the CO/PBX Line is seized, or during an incoming call.
Display
C O / P B X N o .
( 0 1 ~ 6 4 )
0 1 /
T I M E
Settings
LK 1 LK 2
Number Name
Programming Procedures
1 Go off-line.
2 Press LK3 to access the Memory Block.
3 Leave Number set or press LK2 to change to name for the data option for the selected
CO/PBX No. 01, and enter the number or name (refer to Notes).
Use the following to enter data:
J
t o move the cursor left
L
t o move the cursor right
K I
~ t o enter numeric data or CO/PBX No.
D
– OR –
B
to go to the next assigned CO/PBX No.
H
to generate a - (hyphen)
G
to generate a space (clear after hold)
4 Press to write the data. The next Memory Block is displayed.
5 After Memory Blocks 3-02~3-70 are programmed, the next CO/PBX No. is displayed.
E
6 Repeat steps 3~5 for each CO/PBX No. After the last CO/PBX number is programmed, CO/PBX No. 01 is displayed again.
7 Press to go back on-line.
___________________________________________________________________________________
Programming Manual
S e t t i n g D a t a
( 1 3 d i g i t s m a x i m u m )
D I S P L A Y
LK 3 LK 4 LK 5 LK 6 LK 7 LK 8
Default Values
Document Revision 4
CO/PBX Line Mode
3
Submode
—
Data No.
00
PC Programming
+BCT
The shaded
selection is the
default.
Not Specified
2 - 425