Telephone Type Assignment - NEC Electra Elite IPK Programming Manual

Electra Elite IPK
___________________________________________________________________________________
7-2

Telephone Type Assignment

General Description
Use this Memory Block to specify the device that is connected to an ESI port.
Display
E S I
P o r t N o .
( 0 1 ~ C O )
0 1 : T E L
T I M E
Settings
LK 1 LK 2
NON TEL
Programming Procedures
1 Go off-line.
2 Press LK7 + LK2 to access the Memory Block.
3 To change data, press the corresponding CO/PBX line key.
D
Use the following to enter data:
G
to go to next assigned ESl Port No. or cycle back to 1.
E
4 Press to write the data.
5 Press to go back on-line.
Related Programming
Refer to individual features in the Electra Elite IPK Features and Specifications Manual.
1. Only Multiline Terminals can be assigned to ports 01 and 02.
2. A maximum of four Attendant Add-On Consoles can be installed in the system.
3. A maximum of eight SLT(1)-U( ) ADP adapters can be installed in the system.
4. A maximum of 32 Digital Voice Mail ports are available.
5. When assigning SLT adapters or Digital Voice Mail ports, Memory Block 4-10 (Station Number Assignment) must
be reassigned also.
term
D
6. The Cordless II,
7. A maximum of eight basic Message Display Boards and 40 expansion boards are available.
___________________________________________________________________________________
Programming Manual
S e t t i n g
D a t a
D I S P L A Y
LK 3 LK 4 LK 5
CONSOL SLT ADP
term
D
Cordless Lite, or
LK 6 LK 7
DIGITAL
VM
Notes
term
D
Cordless Handset Terminal uses TEL selection.
Document Revision 4
ETU Mode
Telephone
Data No.
—
PC Programming
LK 8
The shaded
selection is the
MSG
default.
BOARD
7
2
+BS
2 - 635