Digit Add/Del For Tie Line Networking Assignment - NEC Electra Elite IPK Programming Manual

Electra Elite IPK
___________________________________________________________________________________
5-00 Digit Add/Del for Tie Line Networking
Assignment
General Description
Use this Memory Block to specify the number of digits to add/delete from the
telephone number sent from a distant system over Tie lines or from DID lines. The
digits enable the system to determine whether a call is directed to the local system or
to a distant system. Refer to Notes.
Display
T r u n k
G r o u p N o . D a t a
( 0 1 ~ 3 2 ) N o .
0 1 / 0 0 : A D D / D E L 0 0 0
T I M E
Programming Procedures
1 Go off-line.
2 Press LK5 to access the Memory Block.
3 Press the corresponding CO/PBX line key to enter the data.
Use the following to enter data:
J
t o move the cursor left
L
t o move the cursor right
D
K I
~ t o enter numeric data
to go to the next Trunk Group No.
Setting Data:
000: No Addition or Deletion
001~009: [1]~[9] Add
010: [0] Digit Add
100~199: [00]~[99} Add
201: 1-Digit Delete
202: 2-Digit Delete
301~309: 1-Digit Delete and 1~9 Add
310: 1-Digit Delete and 0 Add
400~499: 1-Digit Delete and 00~99 Add
501~509: 2-Digit Delete and 1 ~ 9 Add
510: 2-Digit Delete and 0 Add
G
600~699: 2-Digit Delete and 00 ~99 Add
4 Press to write the data and display Memory Block 5-01.
5 After Memory Blocks 5-01~5-03 are programmed, the next Trunk Group No. is displayed on Memory Block 5-00.
6 Program all Trunk Group Nos. Trunk Group No. 01 is displayed again.
___________________________________________________________________________________
Programming Manual
S e t t i n g
T i t l e
D a t a
D I S P L A Y
Document Revision 4
Trunk Group Mode
5
Submode
—
Data No.
00
PC Programming
+ALN
2 - 607