Isdn Dial Interval Time Selection - NEC Electra Elite IPK Programming Manual

Electra Elite IPK
___________________________________________________________________________________
1-1-81

ISDN Dial Interval Time Selection

General Description
Use this Memory Block to specify the time between each digit dialed before digits are
sent over the ISDN PRI line Network. This also applies to K-CCIS outgoing calls.
This Memory Block can be adjusted in 1-second intervals (R3000 or higher).
Display (2500 or lower)
D a t a
N o .
8 1 : I S D N
T I M E
Settings
LK 1 LK 2
2s 4s
Programming Procedures
1 Go off-line.
H A
2 Press LK1 + LK1 +
3 Press the corresponding CO/PBX line key to change the data option.
G
4 Press to write the data and display the next Memory Block.
5 Program the next Memory Block or press
Refer to the next page for R3000 or higher Programming Procedures.
___________________________________________________________________________________
Programming Manual
S e t t i n g
D a t a
T i t l e
D I A L 4 s
D I S P L A Y
LK 3 LK 4
8s 16s
to access the Memory Block.
E
to go back on-line.
LK 5 LK 6
32s
Document Revision 4
System Mode
Submode
Data No.
PC Programming
LK 7 LK 8 The shaded
selection is the
default.
1
1
81
+AN
2 - 101