NEC Electra Elite IPK Programming Manual page 391

Document Revision 4
___________________________________________________________________________________
1-13-05 PRT B Channel-to-Trunk Group
Assignment
General Description
Use this Memory Block to assign a Trunk Group Number to each B channel or any
Trunk Group for each B channel. Changing this assignment is not normally required
and default should be set. This Memory Block could be used when different trunks are
used in the same PRI span or for a tenant application where multiple tenants share the
PRI span and separation of B channels is required.
Display
D a t a
P R T
N o .
1 ~ 8
0 1 / 0 5 : B
T I M E
Programming Procedures
1 Go off-line.
K E
2 Press LK1 + LK13 +
3 Use dial pad keys to enter Trunk Group.
Use the following to enter data:
J
t o move cursor left
L
t o move cursor right
K I
~ t o enter numeric data
00 is No Trunk Group
01~32 are Trunk Groups 01~32
G
4 Press to write the data and display the next B channel or next Memory Block.
5 Program the next Memory Block or press
___________________________________________________________________________________
2 - 314
S e t t i n g D a t a
B C h .
0 1 ~ 2 3 T r u n k G r o u p
0 1 = T G 0 O
D I S P L A Y
to access the Memory Block.
E
to go back on-line.
Electra Elite IPK
System Mode
Submode
Data No.
PC Programming
Default Values
00, No Trunk Group
Memory Blocks
1
13
05
+AN