NEC Electra Elite IPK Programming Manual page 670

Electra Elite IPK
___________________________________________________________________________________
Programming Procedures
1 Go off-line.
F I
2 Press LK4 +
3 Press the Line Key corresponding to CO Message Waiting Indication required for Tel Port No.
The LED indication changes to indicate data each time a CO/PBX Line Key is pressed:
Off Not assigned
On Red: Assigned
Use the following to enter data:
J
t o move the cursor left
L
t o move the cursor right
K I
~ t o enter Tel Port No.
D
– OR –
C
to go to next assigned Tel Port No.
A
to go to the next page
B
to go to the previous page
B
A
+
B
B
+
C
G
+
4 Press to write the data and advance to the next Memory Block.
5 Program the next Memory Block or press
Related Programming
M.B. Number Memory Block Name
1-8-07
Class of Service (Attendant) Feature Selection 1
Page 3, LK 2
3-73
CO Message Waiting Yes/No Selection
This assignment is valid for Multiline Terminals only.
___________________________________________________________________________________
Programming Manual
to access the Memory Block.
t o enter A for Port Numbers 100~109
t o enter B for Port Numbers 110~119
t o enter C for Port Number 120
E
to go back on-line.
Notes
Document Revision 4
2 - 593