NEC Electra Elite IPK Programming Manual page 623

Document Revision 4
___________________________________________________________________________________
Programming Procedures
3 Press the Line Key corresponding to ringing required for Tel Port No.
The LED indication changes to indicate data each time a CO/PBX Line Key is
pressed.
CO/PBX
Line Key LED
Data
Use the following to enter data:
J
t o move the cursor left
L
t o move the cursor right
K I
~ t o enter numeric data or Tel Port No.
D
– OR –
C
to go to next assigned Tel Port No.
A
to go to the next page
B
to go to the previous page
B
A
+
B B
+
C
G
+
4 Press to write the data and display the next Memory Block.
5 Program the next Memory Block or press
Related Programming
M.B. Number Memory Block Name
1-2-26 Delayed Ringing Time Assignment (ICM)
4-12 Line Key Selection for Telephone Mode
1. When Immediate Ring is set, the LED is green.
2. This Memory Block applies only when an SIE or Call Arrival key is programmed for line key appearance.
3. Telephone ports A0~C0 are ports 100~120.
___________________________________________________________________________________
2 - 546
Off Green
Immediate Delayed
No ring
Ring
t o enter A for Port Numbers 100~109
t o enter B for Port Numbers 110~119
t o enter C for Port Number 120
E
Red
The shaded
selection is the
default.
Ring
to go back on-line.
Notes
Electra Elite IPK
Default Values
All Telephones: No Ring
Memory Blocks