Local Operator Call - Dial 9 +0; Service Conditions - NEC Electra Elite IPK Programming Manual

Document Revision 4
___________________________________________________________________________________
CPN
RAB TN NPI
09 0(U) 0(U)
3.8
___________________________________________________________________________________
3 - 48
3.7.9 Local Operator Call – Dial 9 +0
LCR search sequence: Dial 0 of International/Operator Table 1→
RAB 09→ TG 02 → CO 23.
SETUP Message
TNI NIP
No Digits None None

Service Conditions

The following service conditions apply.
The Electra Elite supports the AT&T 5ESS-2000 switch, Software
release 5E12 or later using the National ISDN PRI version only.
Caller ID is displayed as with normal CO calls.
LCR is necessary for Call by Call origination.
For an outgoing call to an external line, dialed digits are sent collectively
when the specified ISDN interdigit dialing interval (MB 1-1-81, ISDN/
K-CCIS Interval Time Selection, 4 sec default) from the last digit expires.
When a digit is not dialed after seizure of the external line before the
interdigit interval times out, the external line is released and a Busy Tone
is generated.
When Call forward Off-premise is assigned, MB 4-47 (ISDN Directory
Number Selection) follows the specification at the TEL to which the call
is forwarded.
No tandem connection is allowed in Tie Trunk Mode.
For PRI trunks, CO or DID type should be assigned using MB 3-91
(Trunk Type Selection).
When PRT is used as an outgoing trunk on Automatic Trunk-to-Trunk
transfer, Caller ID follows the MB 3-52 (ISDN Trunk Directory Number
selection) setting. When allowed, Caller ID is sent to the network.
For an incoming call, the lowest numbered channel in the PRT trunk is
used.
Call by Call does not follow Tenant Day/Night Mode switching.
NSF
F/S
NID Service FCV
FCV
None S MEGACOM
Electra Elite IPK
Service
Feature FCV
Parameter
Operator
None
(Local)
Advanced Applications