Dit/Ana Delay Answer Time Selection - NEC Electra Elite IPK Programming Manual

Document Revision 4
___________________________________________________________________________________
3-61 DIT/ANA Delay Answer Time
Selection
General Description
Use this Memory Block to specify the time an incoming call rings before being
changed to a DIT/ANA call.
This Memory Block can be adjusted in 1-second intervals (R3000 or higher).
Display (2500 or lower)
C O / P B X
N o . D a t a
( 0 1 ~ 6 4 ) N o .
0 1 / 6 1 : D L Y
T I M E
Settings
LK 1 LK 2
0s 5s
Programming Procedures
G
1 Go off-line.
2 Press LK3 +
3 Press the applicable line key to change the time an incoming call rings before it is changed to a DIT/ANA call on CO/PBX NO.
Use the following to enter data:
J
t o move the cursor left
L
t o move the cursor right
K I
~ t o enter numeric data or CO/PBX No.
D
– OR –
G
to go to the next assigned CO/PBX No.
4 Press to write the selected data and display the next Memory Block.
5 Program the next Memory Block or press
Related Programming
Refer to next page for R3000 or higher Programming Procedures.
___________________________________________________________________________________
2 - 482
S e t t i n g
T i t l e D a t a
A N S 0 s
D I S P L A Y
LK 3 LK 4
10s 20s
F A
+ to access the Memory Block.
E
LK 5 LK 6
30s 40s
to go back on-line.
CO/PBX Line Mode
PC Programming
LK 7 LK 8 The shaded
selection is the
50s 60s
default.
Electra Elite IPK
3
Submode
—
Data No.
61
+BCT
Memory Blocks