1-11-03 Ip K-Ccis Selection - NEC Electra Elite IPK Programming Manual

Document Revision 4
___________________________________________________________________________________

1-11-03 IP K-CCIS Selection

General Description
Use this Memory Block to assign the IAD(8)-U( ) ETU used for K-CCIS over IP.
System Software R1500~R1700 or R2500 is required.
Display
D T I N o . D a t a
N o .
( 0 1 ~ 0 8 )
0 1 / 0 0 : F R A M E 0 1 / 0 3 : C C I S o I P
T I M E T I M E
Settings
LK 1 LK 2
NO YS
Programming Procedures
1 Go off-line.
K C
2 Press LK1 + LK11 +
3 Press the corresponding CO/PBX line key to change the data option.
G
4 Press to write the data. The next Memory Block is displayed.
5 Program the next Memory Block or press
Related Programming
M.B. Number Memory Block Name
7-1
Card Interface Slot Assignment
1-15-05
Destination Point Code Transfer Assignment
1-15-06 Originating Office Code Number Assignment
1-15-07 K-CCIS Message Response Timeout Assignment
1-15-08 Link Reconnect Allow/Deny Selection
1-15-09 K-CCIS Maximum Call Forwarding Hop Assignment
1-15-11 Centralized Billing Allow/Deny Selection
1-15-12 Centralized Billing - Point Code of Center Office Assignment
1-15-13
Centralized Day/Night Switching for Remote Office Assignment
1-15-14
Centralized Day/Night Switching for Main Office Assignment
1-15-15
Centralized BLF Send Point Code Assignment
___________________________________________________________________________________
2 - 292
S e t t i n g
T i t l e
D a t a
= 2 4 N O
D I S P L A Y D I S P L A Y
LK 3 LK 4 LK 5
to access the Memory Block.
E
to go back on-line.
LK 6 LK 7 LK 8
Electra Elite IPK
System Mode
1
Submode
11
Data No.
03
PC Programming
+AD
The shaded
selection is the
default.
Memory Blocks