Trunk-To-Moh Trunk Assignment - NEC Electra Elite IPK Programming Manual

Electra Elite IPK
___________________________________________________________________________________
3-12

Trunk-to-MOH Trunk Assignment

General Description
Use this Memory Block to specify the music on hold source for each CO/PBX line.
Display
C O / P B X
D a t a
N o .
N o .
( 0 1 ~ 6 4 )
0 1 1 2 : H O L D
T I M E
Programming Procedures
G
1 Go off-line.
2 Press LK3 + +
3 Enter data for CO/PBX No. using the dial pad to assign the music selection.
Use the following to enter data:
J
t o move the cursor left
L
t o move the cursor right
K I
~ t o enter numeric data or CO/PBX No.
D
– OR –
G
to go to the next assigned CO/PBX No.
4 Press to write the data and display the next Memory Block.
5 Program the next Memory Block or press
Related Programming
M.B. Number Memory Block Name
1-4-17
Automated Attendant Delay Announcement Hold Tone Selection
1-8-09
Music on Hold Pattern Selection
1-8-31
Hold Tone Source Assignment
1-8-32
Hold Internal Tone Volume Selection
3-11
CO External Source Selection
4-66 MOH or Ring Back Tone Selection
1. When set to 00, the CO gets Music on Hold from the MOH jack on the side of the cabinet.
2. When Memory Block 1-8-31 (Hold Tone Source Assignment) is set to INT, this Memory Block is not used.
___________________________________________________________________________________
Programming Manual
S e t t i n g
T i t l e
D a t a
C O 0 0
D I S P L A Y
A B
access the Memory Block.
E
to go back on-line.
Default Values
Notes
Document Revision 4
CO/PBX Line Mode
Submode
Data No.
12
PC Programming
+BCT
00 = Not Assigned for CO/PBX No. 01~64
3
—
2 - 435