NEC Electra Elite IPK Programming Manual page 439

Document Revision 4
___________________________________________________________________________________
1-15-14 Centralized Day/Night Switching for
Main Office Assignment
General Description
Use this Memory Block to assign the Point Codes and the CCH Channel to control
remote systems for Centralized Day/Night Switching.
A CCH Channel of i can be assigned for K-CCIS over IP (R1500 or higher).
Display
T a b l e
D a t a
0 1 ~ 1 6
N o .
1 4 : T 0 1 :
T I M E
Programming Procedures
1 Go off-line.
A D
2 Press LK1 + LK15 +
3 Use dial pad keys to enter Table number, CCH Channel, and Point Code.
Press Redial + 1 to assign i for K-CCIS over IP (R1500 or higher).
Use the following to enter data:
J
t o move cursor left
L
t o move cursor right
K I
~ t o enter numeric data
Point code range is 00001~16367.
Tables 01~16 can be assigned.
G
4 Press to write the data, and display the next Memory Block.
5 Repeat Steps 3 and 4 for each table. The next Memory Block is displayed.
6 Program the next Memory Block or press
Related Programming
M.B. Number Memory Block Name
7-1 Card Interface Slot Assignment
7-3-01 MIF (LCR) Assignment
7-3-02 MIF (SMDR) Assignment
1-15-00 K-CCIS Main/Remote Office Selection
1-15-01 Common Signal Channel Data Speed Assignment
___________________________________________________________________________________
2 - 362
C C H
P o i n t
C h a n n e l
C o d e
1 ~ 4 , i
= 0
D I S P L A Y
to access the Memory Block.
E
to go back on-line.
Electra Elite IPK
System Mode
Submode
Data No.
PC Programming
Default Values :
All Tables Not Specified
Memory Blocks
1
15
14
+AW